Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateFast, Reliable Garage Door Repair Across Sunset
Your garage door is the one part of your Sunset home you use every single day, and when it stops working, the whole routine stops with it. We’re Kendall Garage Door Repair Co, and we handle garage door repair throughout Sunset, from the newer subdivisions off SW 88th Street to the older ranches tucked behind Sunset Drive. Our technicians have up to 10 years of experience across the major door and opener brands, so we’re already familiar with your equipment before the truck pulls up. Call (844) 484-9800. We answer 24/7. Fast dispatch, 7am-7pm, Sunday through Friday.
Why Sunset Homeowners Call Kendall Garage Door Repair Co for Garage Door Repair
Sunset is a built-out, unincorporated corner of the Kendall area, and the work here is almost entirely residential: repairs and replacements on aging 16′ and 9′ steel doors rather than new construction. That shapes how we approach every call. We know what a 1980s concrete-block ranch looks like under the stucco, and we know which parts on those doors tend to fail first.
We also know Sunset’s permit reality. Post-Andrew Miami-Dade wind-load rules mean a garage door permit only closes out with a Miami-Dade NOA or Florida Product Approval label and the matching reinforcement. A cheap out-of-state installer can promise you a door; handing you a passing inspection is another matter. We work with the labeled products and hardware that meet those rules.
Our brand coverage matters here too. Homes across Sunset run everything from original builder-grade openers to newer Wi-Fi LiftMaster and Chamberlain units, plus doors from Wayne Dalton, Amarr, Clopay, Craftsman, Genie, and Raynor. We service all of them, and we don’t hand you off because your model is unfamiliar. Expect an honest assessment, a clear repair plan, and pricing you agree to before anyone touches the door.
If your door is stuck open, stuck closed, or jumped its track, we treat it as urgent. Call (844) 484-9800 and we’ll get a technician moving toward Sunset.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Garage Door Repair Services in Sunset
Sunset’s housing stock is mostly 1960s-1990s single-family ranches and low-rise townhomes, and that tells us a lot before we arrive. Builder-grade doors installed decades ago near the end of their rated life produce a predictable set of failures. Here’s what we fix most.
Panel Replacement in Sunset
Steel panels on Sunset homes rust through along the bottom weather seal long before the rest of the door gives out. Year-round humidity and heavy summer rain work on that bottom edge until the metal is gone. A typical panel replacement in Sunset runs $250 – $500, and we source panels that carry the right labeling for your existing door system so the repair holds up and inspections pass.

Spring Repair in Sunset
Torsion springs are under enormous tension, and this is not a job to attempt yourself. When a spring reaches the end of its rated cycles, the opener strains to lift a 150 – 350 lb door, and many homeowners assume the opener is failing when the spring is the real culprit. A typical spring repair in Sunset runs $180 – $340 for one spring; a matched pair is usually replaced together, so a pair costs about twice that. We replace springs safely and check balance afterward.

Cable Repair in Sunset
Cables lift the full weight of the door alongside the springs, and a frayed or snapped cable can drop a door fast. Rust and seized rollers accelerate the wear in this climate. A typical cable repair in Sunset runs $130 – $250, and we inspect the drums and lift brackets at the same time so a fresh cable isn’t paired with failing hardware.

Track Realignment in Sunset
Doors that hit something, or whose tracks have shifted with age, bind and grind their way up and down. When tracks and hardware get replaced with non-NOA parts, the door can’t be labeled for permit close-out even if it runs smoothly. A typical track realignment in Sunset runs $120 – $240. We straighten the track, check the end bearing plates, and confirm the door balance before we call it done.
Trusted Brands We Service in Sunset
We service doors and openers from LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, and we’re certified to work on eight of the most widely installed residential brands on the market. That means we arrive fluent in your system rather than learning it on your driveway. We don’t claim to stock every part locally, but our brand familiarity keeps diagnosis quick and turnaround tight. If your Sunset home has a smart opener from LiftMaster or Chamberlain, or an older Wayne Dalton or Raynor door that’s been grinding for months, we’re set up to handle it.
See the difference
Before
After
Before
After
Before
AfterCommon Garage Door Repair Problems We See in Sunset Homes
Every neighborhood has its patterns. In Sunset, these come up again and again.
- Rusted bottom panels. Builder-grade original steel doors on 1960s-1990s homes rust through along the bottom weather seal after years of salt-laden humidity, so panel replacement, not a coat of paint, is often the real fix.
- Strained openers on tired springs. Torsion springs that have run past their rated cycles leave the opener straining to lift a 150 – 350 lb door, and homeowners often misdiagnose a failing LiftMaster or Chamberlain unit when the spring is at fault.
- Sagging doors on one side. In a 1970s – 90s Sunset ranch, the original 16′ builder-grade steel sectional door usually starts sagging a few inches off the ground on one side. The cause is typically a spring at end of life plus rusted rollers seizing on corroded hinges, not the opener.
- Track and hardware mismatches. When tracks and hardware are replaced with non-NOA parts, wind load and door balance get thrown off, so the door can’t be labeled for permit close-out and inspectors reject mismatched end bearing plates and bracing.
Here’s how a typical repair goes in a Sunset home: we measure the door balance, replace the torsion spring pair with high-cycle springs, free or swap the rusted rollers, realign the track, and adjust the drums. Then we re-tension the opener rail and calibrate the photo-eye sensors so the door closes flush against a fresh weather seal. That sequence matters because fixing one part without the others just moves the failure down the road.
Pricing for Garage Door Repair in Sunset, FL
We want you to know roughly what to expect before you call, so here are typical estimated ranges for garage door work here. These are estimates for Sunset’s market; the written estimate sets the final price, and nothing starts until you’ve reviewed and agreed to it.
| Service | Typical Estimated Range |
|---|---|
| Garage Door Repair | $150 – $600 |
| Panel Replacement | $250 – $500 |
| Spring Repair (one spring) | $180 – $340 |
| Track Realignment | $120 – $240 |
| Opener Repair | $120 – $320 |
| Roller Replacement | $110 – $220 |
What pushes a job toward the top of a range? The number of parts that have failed together, whether the door needs matching labeled hardware for permit close-out, and the age of the original installation. We’ll walk you through the findings and explain what’s urgent versus what can wait. Estimates are free.
We Also Serve Cities Near Sunset
Sunset sits in the middle of a cluster of similar residential neighborhoods, and we serve the surrounding communities too. If you’re near Olympia Heights, Westwood Lakes, Richmond Heights, or Sunset itself and your garage door needs attention, we can help. The housing stock and permit rules are similar across these areas, so the same labeled products and reinforced hardware apply. Call us and we’ll confirm coverage for your address.
Serving Sunset, FL – Our Local Coverage Area
We serve Sunset and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Garage Door Repair in Sunset
The spring, not the opener, is almost always the cause. When a torsion spring wears past its rated cycles, the opener has to lift the full weight of a 150 – 350 lb door on its own, which is why it strains and grinds. Replacing the spring restores balance and takes the load off the opener. Call (844) 484-9800 for an exact quote; estimates are free.
Yes. Because Sunset is in unincorporated Miami-Dade, a garage door permit only closes out with a Miami-Dade NOA or Florida Product Approval label and the matching wind-load reinforcement. Mismatched hardware or a missing label fails inspection even on a simple panel swap. Ask your city’s building department to confirm what your specific job requires. Call (844) 484-9800 for an exact quote; estimates are free.
Torsion springs run horizontally on a shaft above the door’s center; extension springs stretch vertically along the sides. Most newer Sunset homes and 16′ steel sectional doors use torsion. Either way, spring work is high-tension and dangerous, so don’t test or adjust it yourself. Call (844) 484-9800 for an exact quote; estimates are free.
If the rust has eaten through the metal, the bottom panel needs replacing, not painting. Salt-laden humidity and heavy summer rain attack that bottom weather seal until the steel is gone. A typical panel replacement in Sunset runs $250 – $500. Call (844) 484-9800 for an exact quote; estimates are free.
Most garage door replacements in Sunset need a permit through unincorporated Miami-Dade, and the labeling requirement typically travels with the job. The labeled product and matching reinforcement have to be in place before inspection. Call (844) 484-9800 for an exact quote; estimates are free.
If your garage door is straining, sagging, rusted, or jammed, don’t wait for it to fail completely. We’re a single-trade shop that does nothing but garage doors, so you get a specialist who knows your equipment, not a jack-of-all-trades guessing at it. Call (844) 484-9800 for a free estimate. We answer 24/7. Fast dispatch, 7am-7pm, Sunday through Friday, and the price is quoted and agreed before any work starts.
Written by the team at Kendall Garage Door Repair Co.